Fixer Upper 12am 11c.

Jul 29, The smaller gaps will have to be caulked at the bullnoses. You could add trim to the treads and risers, but it will look like an afterthought. Blow the dust out of the gaps. Then use masking tape about 1/8" off the wall on each stair tread and riser.

This will provide straight clean lines for the caulk so it doesn't look like a shrubhauling.barted Reading Time: 8 mins. Trim on the outside of the staircase lies under the tread of the stairs. Measure the underside of the tread of each step and cut each step in the stringer to fit. Place the stringer under the steps and nail the stringer into place.

Counter sink the head of each nail and putty the hole over the nail head. Do work at least one riser ahead before installing treads. Installing two risers is one way to ensure proper strength and performance. The important thing is to remember to install riser, tread, riser, tread or install the risers first.

Do use both adhesives and fasteners when. Use a very sharp pencil and trace a line along the top of the entire piece of scrap trim. Now place the trim on the sloping stringer and slide it up so the bottom of the trim projects up past the flat landing.

Do so until the top of the trim intersects the pencil line you just drew on the shrubhauling.barted Reading Time: 6 mins. Sep 04, Step 2 – Measure Each Stair Tread and Riser Use the template tool and measure the tread.

Lay the template on top of the new tread. Wrap the painter’s tape under the ends of where the tool indicates you will cut. (The tape is not necessary but makes it Score the tape using the utility knife to Estimated Reading Time: 8 mins.

Simply cut the bullnose to length with a miter saw, place it in the corner where the tread meets the riser and use a pin nail gun to fasten it in place. Bullnose adds a finished look to stairs, and. Feb 27, When installing stairs, install the riser first, and then the tread. Start at the bottom of the stairs and work your way up, alternating risers and treads. The back of each tread will sit flush against the riser. Treads and risers fasten with construction adhesive to the subfloor.