Don't worry about the nut position on this end, the.

Apr 11, Take the fork's lower and angle the washer so it can slide past the bushing (the reason for the flat sides) and then get the washer flat and pull it up against the bushing's underside. Once there you can either use a slide hammer to pop the bushing out, or put another washer and nut on the threaded rod and tighten it down on the top of the lower and pull the bushing out like shrubhauling.barted Reading Time: 8 mins.

Just gently tap on the top of the fork tube using a wood block and a rubber mallet to free the tube and try it again. I found that it seems to work better with smaller, shorter strokes, rather than big “as hard as you can” strokes. Once you get the fork tubes separated, remove all of the loose bushings, washer, and seal from the tubes and clean.

Aug 27, Take the fork's lower and angle the washer so it can slide past the bushing (the reason for the flat sides) and then get the washer flat and pull it up against the bushing's underside. Once there you can either use a slide hammer to pop the bushing out, or put another washer and nut on the threaded rod and tighten it down on the top of the lower and pull the bushing out like shrubhauling.barted Reading Time: 2 mins.

Jan 19, Finished by sanding off any burrs. Put it on a long piece of all-thread and put a smaller washer behind it stump removal high point nc to add some stiffness. Fits nicely into the lowers Secure the other end of the all thread into a vice. Tap, tap, tap at the top of the lowers with a rubber mallet.

Out comes the upper bushing. Dec 27, Put the bike on the center stand and jack up the front so the wheel is slightly off the ground. Take the front wheel and fender off the bike. Loosen the upper pinch bolts that are holding the very top of the fork legs by the caps. Use a 24mm wrench and loosen the fork shrubhauling.barted Reading Time: 11 mins.